www.jakohardware.com
DEADBOLTS
Unscaled format
DEADBOLTS ONLY THUMBTURN
HOW TO INSTALL YOUR SECURITY AUXILIARY EMBED LOCK
For single cylinder / For double cylinder
HOW TO DETERMINE THE DIRECTION
OF THE DOOR
DRILL THE GAPS
1
MARK THE GAPS
2
3
INSTALL THE LATCH
LATCH POSITION
4
5
Select the height from the floor to install
the lock. Fold the pattern along the dotted
line. Mark pints 1 and 2 (2`).
Drill a 54mm hole centering at point 2 (2-1/8”)
Drill a 25mm hole centering at the point 1
Insert the latch through the 25mm hole. Mark the outline of
the front. Make a 3mm deep box. Then secure the latch.
Note: The arrow indicates the direction of installation.
Indicate the installation process always with the handle
outside the case as shown in the figure. Since otherwise
the instructions of the numeral 6 are reversed.
Left
door
Right
Door
INSIDE
EXTERIOR
Latch slot.
Latch.
Cod. CER-285 / CER-2854
Installation guide
