Cod.RD101CP / RD101CP-AS / SD01CP
Installation guide
TOOLS REQUIRED FOR REMODELING OR
NEW CONSTRUCTION:
TOOLS REQUIRED FOR REPLACEMENT:
FOLLOW STEPS 6,7,8,9,10 FOR DO IT YOURSELF
REPLACEMENT, FOLLOWING REMOVAL OF EXISTING LOCK.
1 philips head screwdriver
1 philips head screwdriver
1 2” hole saw
1 1” drill
1 chisel
1. MARKDOOR
2. DRILL HOLES
A. Fold and apply template to high
edge of door bevel and mark
center of door edge as indicated
on template at the desired
height from the floor.
A. Drill thru door face as marked
for lockset: It is recommended
that holes be drilled from both
sides to prevent splitting. Hole
size is 2” for standard installations.
B. Drill 1” hole in center of door
edge thru to 2” hole for latch
B. Mark center hole on door face
through guide on template. For
either 2 3/8” , 2 3/4” bakset..
3. INSTALL LATCH
4. INSTALL STRIKE
A. Close door against door stop.
Insert edge of template
against the flat side of latch
bolt, and mark template at
edge of door, jamb to locate
strike opening. Move 3/8”
toward door stop to locate
center line for screws and 1”
hole. This will insure the
proper location of the strike.
A. Insert latch in hole, keeping
it parallel to face of door.
Mark outline and remove
latch.
B. Chisel 1/8” deep or until latch
face is flush with door edge.
B. Install deadbolt latch in
“up” position into hole
as shown on latch.
Insert and tighten
screws.
B. Chisel 1/16”
deep for strike
matching 1”
hole in door
jamb. Insert
and tighten
screws.
INSTRUCTION FOR ADJUSTABLE DEADBOLT
TO CHANGE 2-3/8” TO 2-3/4”
Thumb press the end of the latch,
with the Adjustable Slot facing toward yourself,
turn the body of the latch clockwise and
make sure that THE PIN DROP INTO THE SECONDARY
SLOT, THEN PULL TO THE SIDE. Twist the body of the
latch counter clock wise TILL THE PIN DROP INTO THE
UPPER PRIMARY SLOT.
60mm (2-3/8”)
70mm (2-3/4”)
PRIMARY SLOT
SECONDARY SLOT
DEADBOLTS
Unscaled format
www.jakohardware.com
DEADBOLT LOCK KEY-THUMBTURN
