Device Overview
Important Notice
The device comes with a battery
pre-inserted. Before using the device, the
insulation sheet must be removed in order
to use the device.
Please remove the insulation sheet as
shown in the image illustrated. (Improper
removal of the insulation sheet might end
up breaking the insulation sheet.) Once the
battery fails to activate, you will need to
open the battery cover, and remove scraps
of the broken sheet.
Installation
This device can also be installed in shoes that come with
insertion slot for this sensor, such as Nike or Adidas shoes with
special feature marks.
(Lift up sock liner and insert this sensor into the slot with LOGO
facing up)
Rear Side
Shoelace Hole
Screw
LOGO Side
LOGO Side
Clip
Insulation Sheet
POD1605
To install the clip, slide the clip forward along
the back of the sensor until the sensor is
securely snapped into the clip latch.
This device can be clipped onto shirt pocket, collar or
around waist. Please make sure the device is securely
snapped into the clip before use.
To detach the clip from the sensor,
pull up the clip latch in order to
eject the sensor.
Insulation Sheet
Battery Cover
User Manual
POD1605
Foot Pod Sensor
EN
Install Device into the Slot of the Sneaker
Important Notice
While tying the shoelace, pull one through
from upward while the other from
downward, and make sure the LOGO side
faces up.
Please try to keep the device at horizontal
level, for excessive tilting might cause
incorrect detection.
When the device is tightened on the shoelace, make sure the LOGO side faces up, while
the shoelace should be pulled through the two shoelace holes aside the device and tied
with a knot to fasten the device.
Use clip
Install & Uninstall Clip
Install the sensor on top of Sneakers
LOGO side facing down
Excessive tilting
1b
1a
1c
