NU-0528i/NU-0548i Mini-ITX Chassis
RISER CARD & FRONT 2.5” HDD ASSEMBLY
(1) With Riser Card Expansion system integration, -
The Slim ODD+2.5”HDD Bay and/or 3.5” HDD Bay are no
longer installable due to space limitation in the smaller
dimensioned Mini-ITX Chassis.
(2) To install the Riser Card, -
Break off and remove the ‘Punched-but-not-perforated’
Slot Cover (For Standard PCI Card) from the Rear Panel,
Unscrew and take out the Card Holder Bracket.
Insert the Riser Card into the Motherboard’s PCI Slot and,
Use 2 pcs of 6-32*L6 Hexagon Head Screws to secure the
Riser Card on the Center Bar.
(3) Insert your Expansion Card horizontally into the PCI Slot of
the Riser Card.
Fit back the Card Holder Bracket on the Rear Panel and, -
Use 1 pc of 6-32*L6 Hexagon Head Screw secure the Card
Holder Bracket on the Rear Panel.
(4) With Riser Card expansion system integration, -
1 pc of 2.5" HDD is installable on the inner side of the Steel
Front Panel.
Note: This installation of the 2.5" HDD would obstruct and
invalidate the Card Reader integration.
