INSTALLATION INSTRUCTIONS
MLP1J1 MonoLine
®
End Feed
MLP1J4 MonoLine
®
“L” Joiner Feed
SAVE THESE INSTRUCTIONS and refer to them when making any additions or
changes to the track configuration.
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions prior to installing this product.
2. Disconnect electrical power before adding to or changing the configuration of the track.
3. Do not install this track in damp or wet locations.
4. Do not install any part of track system less than 5 feet above floor.
5. Do not attempt to energize anything other than lighting fixtures and fittings intended for use on MonoLine track.
Important: Each section of track must be supported in at least 2 places. Use a Track Support in addition to this Feed.
WARNING
BE SURE TO TURN OFF POWER TO THE JUNCTION BOX BEFORE INSTALLATION.
MLP1J1 MonoLine End Feed
MLP1J4 MonoLine “L” Joiner Feed
Make sure main power to system is OFF.
Remove Back Plate from Canopy Cover
by loosening two screws.
Attach Back Plate to junction box using
screws provided.
Connect Feed wires to junction box wires
using wire nuts, black to black, white to white. Push
wires up into junction box.
Reattach Canopy Cover to Back Plate
and tighten screws.
Follow track connection steps on page 2.
6
5
4
3
2
1
Conduit Collar
(not shown)
s
MLP1J1
MLP1J4
1 of 2
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc. Rev 3/17 P3198
