BEFORE INSTALLING AND USING THE PRODUCT,
PLEASE READ THE INSTRUCTIONS THOROUGHLY,
AND RETAIN THEM FOR FUTURE REFERENCE.
PRODUCT OVERVIEW
1.
Charging Port
2.
Power Indicator
3.
AC Plug
Included
:
(1x) 4 Port USB Power Hub (USB charging adaptor) and
(1x) Instruction Manual
SPECIFICATIONS
To ensure safe operation, check your device’s
compatibility with Power Hub specifications prior to use.
USE
1.
Flip out the AC plug of the 4 Port USB Power Hub.
2.
Plug the 4 Port USB Power Hub into any powered
wall outlet. A blue power indicator below the USB
ports will light up.
3.
Plug the USB cable from your charging device(s)
into any USB port of the 4 Port Power Hub to begin
charging.
PLEASE NOTE
• Certain USB powered devices require the use of their
original charging cable to charge efficiently. If you do
not use the original cable, your device might not
charge successfully.
• This 4 Port USB Power Hub has a built-in intelligent
identifying chipset. If you’re charging an iPad
®
or tablet
that requires a high charging current, (up to 2.4A) the
charging port will automatically supply the matching
charge needed for the device (the Super Charger is
now active). The remaining ports can charge an
additional 2 smartphones OR a second tablet only.
NOTE:
Charging LED indicator will blink & Power Hub
will beep if too many high powered devices are
attached. Remove one device to continue charging.
• It is normal for the 4 Port USB Power Hub to become
slightly warm during use.
SAFETY INSTRUCTIONS
• Please read this manual carefully before using.
• Keep this device away from children. Never let children
use this device without supervision.
• If you detect any smoke, fumes or unusual odors or
noises, remove the USB adaptor from the main socket
immediately. In these cases the device should not
be used until it has been inspected by authorized
service personnel.
• Never connect the USB charging adaptor to any
devices containing non-rechargeable batteries, as
these can explode during charging.
• Only connect the USB charging adaptor to a freely
accessible main socket so that it can be quickly
disconnected from the main in the event of danger
(smoke, fumes or smell of burning).
• Always disconnect the USB charging adaptor from
the main supply if no device is being charged.
Unit consumes power, even if it is not connected to
a device. This minimizes the risk of fire which always
exists when an electrical device is connected to the
main power supply.
• Always disconnect the USB charging adaptor from the
main power supply before a storm or thunderstorm if
there is the risk of lightning, as the USB charging
adaptor and the connected device can be irreparably
damaged by the high voltage surge if lightning strikes.
• A damage or incorrectly installed main socket can
cause a fire or electric shock. Only connect the USB
charging adaptor to sockets which are intact as well as
completely and correctly fitted.
• This is also the risk of fire if the USB charging adaptor
is not fully inserted into the main socket and there is
a loose connection as a result.
• Never use any adaptor plugs or extension cables
which are damaged or which do not comply with valid
safety standards.
• To disconnect a cable always hold the USB charging
adaptor and pull the plug, not the cable. Ensure that
the cable is not kinked and does not cause an
obstruction.
• If the USB charging adaptor is exposed to extreme
temperature fluctuations, condensation can lead to the
accumulation of moisture, which can cause a short
circuit. In this case wait until the USB charging adaptor
has reached ambient temperature before use.
• Protect the USB charging adaptor against moisture,
vibration, dust, heat and direct sunlight. It could be
damaged as a result.
• Avoid dropping or applying excessive shock and force
to device.
• Do not attempt to disassemble the device. Any
attempts to do so will void all warranties on this
product.
• Upon the event where the device may be broken,
shattered, or in any way physically compromised,
DO NOT USE DEVICE.
• Ensure charge port is clear of any foreign objects and
debris before using.
• Do not force incompatible connectors into any port.
• Please handle the product carefully. Jolts, impacts or
a fall even from a low height can damage the product.
• The device is not a toy. Keep it out of the reach of
children and pets.
MAINTENANCE
• Disconnect the USB charging adaptor from the main
socket and remove all connected devices before
cleaning it. Otherwise there is the risk of fatal injury
caused by electric shock.
• If soiled, clean the USB charging adaptor with a dry
cloth, and moisten the cloth slightly to remove
stubborn dirt. Do not use any solvents, corrosive or
gaseous cleaning agents. Ensure that no moisture
penetrates the adaptor.
FCC STATEMENT
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user authority to operate the equipment.
NOTE:
This equipment has been tested and found to
comply with the limits for Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on. The user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
CALIFORNIA PROP 65 WARNING
WARNING:
This product contains chemicals known to
the State of California to cause birth defects or other
reproductive harm. For more information on these
regulations and a list of chemicals, log on to the following
website address:
http://www.oehha.ca.gov/prop65.html
INNOVATIVE TECHNOLOGY ELECTRONICS CORP.
LIMITED WARRANTY: 90 DAYS LABOR, ONE YEAR PARTS
Innovative Technology Electronics Corp. (IT) warrants the product to be free from
“Defects” in materials under normal use for a period of “One Year” from the date of
the original purchase. The Warranty is “Not” transferable. IT agrees, within the
initial “90 Day” period, to repair or replace the product if it is determined to be
defective at “No Charge”. It is further agreed that IT will cover the cost to repair or
replace damaged “Parts” only for a total period of “One Year” from the date of the
original purchase. The warranty does not cover cosmetic damage, antennas, AC
cords, cabinets, headbands, ear-pads, or damage due to line power surges,
connection to improper voltage supply or settings, misuse, mishandling, accident,
acts of God or attempted repair by an unauthorized service agent.
To obtain service, the purchaser MUST present an original sales receipt / proof of
purchase. Please contact us at www.ithomeproducts.com to request an RMA (Return
Material Authorization) number to return products for service or replacement. Returns
without an RMA number on the package will be refused and returned to sender.
Upon receipt of the returning item and our full inspection (IT) may issue a
replacement to customer for the same item or of one that has equivalent value and
features. To return an item, supply full name, return address, phone number, item
purchased, receipt of purchase and reason for return to obtain RMA number.
All returns must be in the original packaging or reasonable substitute to prevent
damage. Customer “Must” include full name, shipping address and telephone
number inside of package. No return will be shipped back to a PO Box or
APO address.
Please include your check or money order in the amount of:
•
USD$5.00 for items $10.00 to $39.99 (Price Paid Per Unit)
•
USD$10.00 for items $40.00 to $99.99. (Price Paid Per Unit)
•
USD$16.00, for items $100.00 and up. (Price Paid Per Unit)
•
Shipping fees are non-refundable
To be payable to Innovative Technology Electronics Corp.(for handling and return
shipping charges) (IT) will not be responsible for delays or unprocessed claims
resulting from a purchaser’s failure to provide any / all of the necessary
information. Send all inquiries or RMA request via our website:
www.ithomeproducts.com/support.
Innovative Technology Electronics Corp.
1 Channel Drive
Port Washington, NY 11050
Toll free: 1-877-483-2497
Website for support: www.ithomeproducts.com/support
There are no express warranties except as listed above.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE
EXCLUSIVE REMEDY OF THE CUSTOMER, (IT) SHALL NOT BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR
IMPLIED WARRANTY ON THIS PRODUCT EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO THE
DURATION OF THIS WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, or limitations on how long an implied warranty lasts, so the above
exclusions or limitations may not apply to you. This warranty gives you specific
legal rights and you may also have other rights, which vary from state to state.
NOTE: As a result of continual improvements, the
design and specifications of this product are
subject to change without notice.
Apple, iPad and iPhone are trademarks of Apple Inc., registered in the
U.S. and other countries. Other trademarks & trade names are those of
their respective owners. Smartphones and Tablets are NOT included.
4 Port USB Power Hub
Model:
JH-810
USER MANUAL
1
by
