zRAMP
Quick Setup Guide
Zixi ONAIR app
Decoder
BR-DE900
The zRAMP Video-over-IP server accepts Zixi transport protocol from JVC cameras and Zixi ONAIR iOS/Android app.
Zixi protocol utilizes Forward Error Correction (FEC), Repeat Request (ARQ) and Adaptive Bit Rate (ABR) to
compensate for up to 30-40% of packet loss due to network congestion, limited bandwidth and excessive jitter.
The zRAMP outputs UDP, RTP, RTP+SMPTE FEC and RTMP streams to hardware/software decoders, CDNs (Facebook,
YouTube etc.) and SW video switchers (ProHD Studio, vMix).
Zixi QoS - The Most Resilient Video Transport over the Internet
The zRAMP is a
Network Attached Appliance
and is controlled/operated via browser from another PC or smart device
on the same network or via WAN / Internet. Recommended browsers: Chrome, Mozilla Firefox.
(Please, do not connect a monitor to the DisplayPort, only Linux login will be displayed.)
zRAMP login:
Setup PC network adapter: IP =
192.168.1.77
(or similar), Netmask =
255.255.255.0
Launch Chrome browser, type
http://192.168.1.7:8080
, Login =
admin
Password =
jvc1234
Connection via WAN / Internet
In most cases, the zRAMP would be connected to the Internet via router/firewall gateway.
The following ports need to be forwarded to the zRAMP local IP address:
UDP 2088
for incoming video stream.
TCP 8080
to enable login from the Internet / WAN
TCP 7777
to stream Flash preview to the Internet / WAN
TCP 4500
HTTP proxy for files transfer
TCP 22
SSH for service
192.168.1.7
Internet
Router
Firewall
zRAMP
Port Forwarding
UDP 2088
TCP 8080
TCP 7777
Gl
ob
al
IP
a
dd
re
ss
Lo
ca
l IP
a
dd
res
s
WAN
TCP 4500
DHCP
