Pull Cord Set
for N86
T.200.001.589
The package contains the following items :
2 x Press-fit nuts M3
2 x Screws M3
Pull switch with
break-away part
1 x 2m cord with break-
away part and cone
New special
battery trap
1 x Wire 60 mm
1 x Wire 40 mm
Disassemble the device :
1. Remove the battery trap
2. Remove the battery
3. Remove the 4 screws
4. Remove the bottom housing
5. Remove the PCB
Prepare the switch :
1. Insert the 40 mm wire into the switch contact
2. Insert the 60 mm wire into the switch contact
3. Put the screws M3 into the holes of the switch
WARNING !
The N86 should be opened in an ESD pro-
tected environment with respect to the
necessary precautions : discharge your-
self from electrostatic loads by touching a
grounded conductive surface before opening the unit.
1
2
1
2
3
3
1
This package contains
all the necessary parts
to add to an N86 trans-
mitter the possibility to
trigger an alarm using a
pull cord.
This kit cannot be ins-
talled in a N46 trans-
mitter.
