936.1533/e Subject to alteration.
738 440
Page 1 of 2
Elevation
compensation
Precise azimuth adjustment for mast mounted antennas can easily be achieved by using the azimuth
adjustment tool.
This tool is suitable to all types of Panels and Tri-Sector Pipe Antennas with a maximum width
of 315 mm.
Instruction:
– Use a map to work out the angle between the designed antenna azimuth and target
(church, building, mountain peak).
– Set this angle on the scale of the adjustment tool.
– Place the adjustment tool onto the antenna and tighten the clamping device.
– Use the telescope to aim at the target object, if necessary, use elevation compensation.
– Then rotate the antenna until the target object appears in the telescope.
* Observe the position of the stopper when fitting the azimuth adjustment tool.
Target object
Clamping device
Scale
Panel
Move the stopper to central position*
Target object
Azimuth Adjustment Tool
738 440
Kathrein USA Greenway Plaza II, 2400 Lakeside Blvd., Suite 650, Richardson TX 75082
Phone: 214.238.8800 Fax: 214.238.8801 Email: info@kathrein.com
All specifications are subject to change without notice.
The latest specifications are available at www.kathreinusa.com
