This unit requires purified or distilled water,
which significantly improves the ice quality
and ice production. Water with a TDS or
hardness of <100 PPM is also acceptable.
Water with over >100 PPM will cause the unit
to go into "Clean” Mode frequently and not
produce ice.
TDS
KBice 3.0 Self-Dispensing Nugget Ice Dispenser
QuickStart Guide —
FDFM1JA07
INSTALLATION
Clearance Requirements
CAUTION
This unit is designed for household countertop use
only.
Never block the air vent on the left side.
The unit operates in an area with a maximum
ambient temperature of 85°F. Therefore, the warmer
ambient temperature will result in reduced ice
capacity and quality.
Never operate this unit in direct sunlight.
Allow for a minimum clearance of 4 inches on both
left and right sides, 2 inches on the back, and ½ on
the top to ensure the proper functionality of the unit.
Scan here for instructional video:
Electrical Requirements
DANGER
This unit requires that you connect only to a
GFCI protected receptacle.
Strongly advised that you do not use an adapter
to connect this unit because of safety hazards.
A dedicated 120V, 60Hz, 15A fused, grounded
electrical supply is required.
Water Requirements
Call or Text “Help” 800.433.9938 | info@kbgoodice.com | www.kbgoodice.com
8
6
7
4
2
3
1
5
1. Display Panel
2. Ice Dispense Point
3. Water Fill Port
4. Drain Tube Plugs/Holder
5. Water Tank
6. Air Vent
7. Side Tank’s Base
8. Drip Tray
