2
Warning
When installing, servicing, or replacing parts for this product, do not perform any action that is not prescribed in the
owner's manual.
Do not apply excessive force to the electronic components or connectors on the circuit board, and do not disassemble it.
Electrical shock, fire, or malfunction may result.
Before installing this product, disconnect the power supply cable of the device in which it is being installed, and discon-
nect any cables that connect peripheral devices. Failure to do so may cause electrical shock or malfunctions.
Caution
Do not allow this product to become wet, and do not place objects on top of it. Doing so will cause malfunctions.
Before touching this product, touch a metal part of the device into which it will be installed, so that any static electricity
in your body will be discharged. Failure to do so will risk damaging the electronic components by static electricity.
When handling this product, be careful not to touch the leads (wires protruding from the electronic components) on the
rear side of the circuit board. Injury may result.
When installing this product, do not touch any unrelated parts or circuit boards. Electric shock or malfunction may result.
When installing this product, be careful not to cut yourself on any sharp edges or parts of this product or of the device into
which this product is being installed.
When installing this product, be careful not to drop screws etc. into the device into which this product is being installed.
The manufacturer makes no warrantee regarding possible malfunctions or damage that may result from improper use or
modification. The manufacturer also will take no responsibility for any damages that may result from loss or disappear-
ance of data.
Installing this product
For the procedure of installing this product, refer to the owner's manual of the device into which the product is being
installed. If you have any questions, please contact your local Korg distributor.
Cautions when installing an option board
In order to install the board correctly, please pay attention to the following points.
Be careful of static electricity, which may damage components inside the product or on the board. Before beginning the
installation, touch an unpainted metal part of the chassis or the grounding terminal of a grounded device to discharge any
static electricity that may be present in your body.
Perform the installation according to the steps given in the directions, making sure that the board is installed correctly and
in the correct orientation.
Verify that the option board has been installed correctly. If installation is incorrect, faulty connections or a shorted power
supply can cause malfunctions.
All the screws that are removed will be used, so be careful not to lose any.
Using screws of the incorrect shape or length can cause malfunctions or damage to the product. Use only the screws that
were included with the option board or the screws that were fastened in the instrument.
When installing or removing the board, be careful not to drop parts or the option board into the instrument.
Make sure that the attaching screws are tightened firmly, and are not loose.
Handle the board with care. Subjecting it to physical shock (by dropping or pressing it) may cause damage or malfunctions.
Be careful not to touch any exposed metal portions of the circuit board, or any parts that are not essential to the installation
process.
