(FBS4
GSPOUJFSDMBTTJD
b
g
a
c
Strap buckle
Gear S3
Screw
(Silver)
Caution on the
assembling direction
g
c
Position of screws
to be removed
Gear S3
Caution on the
assembling direction
Array the Charging & security cable( ) into the cable guide of the cradle
properly, insert it into the hole on the table in the direction to the rear side of
the cradle and attach it on the proper position firmly.
Insert the Charging & security cable( ) into the hole on the smart table
while facing downward, and attach the cradle over the hole on the table.
A
- Installing on the smart table
1.After removing the protective film from the double-sided adhesive tape, preserve the
tape so that it doesn't get dirty.
If touching the tape with a hand or foreign materials get on it, its adhesive strength
can be significantly deteriorated.
2.The adhesive tape will have full adhesive strength after the 24 hours from its placement.
Please do not use the products right after its placement.
- Cautions when attaching the double-sided tape.
Gear S3 frontier/Gear S3 classic
Normal Security Set
INSTALLATION MANUAL
G022_EN1610_R02
Please, read carefully the installation manual before installing it, and install it
according to the manual. Please, keep the manual for a future reference.
▶
Before installing,
Please check up the parts.
Maintenance kit
m1
■
Maintenance kit
Use if the product needs to be reinstalled.
m2
▶
Installation Guide - Gear S3 frontier/classic Normal Security Set
2
-A
2
-B
■
Assembling flow
c
d
e
f
g
a
a
a
a
a
b
Hole on the
smart table
Loosen the screw (silver) in the direction where the strap buckle side using the
screw driver included in the package.
※
Make sure that the screw in the direction where the buckle side be loose.
※
Keep the screw (silver) separated from Gear S3 carefully.
3
Assemble the Security sensor( ) along Gear S3 while paying attention to the assembling
direction. After assembling the Security sensor correctly, fix the Gear S3 and the Security
sensor firmly using the black screw( ) for fixing the Security sensor included in the package.
※
Before assembling the product, make sure to check the screw color(black).
4
g
c
Hole on the
normal table
a
a
Remove the protective film from all double-sided tapes on the bottom surface of
the cradle( ).
1
b
b
Remove the
protective film
Refer to
Caution A.
B
- Installing on a normal table
CAUTION A.
