background image

This setup instruction guide will show you the easy steps 
to  set  up  your  L.L.Bean  Stowaway  Pocket  Pedometer 
OJBL1.

 Unpack

Make sure you have all the parts shown here before 
setting up your pedometer.

         
 
 

               

1 x Pedometer

 B 

 

Activate Pedometer

1.  Remove the pedometer from the belt clip.
2.  Pull plastic strip to activate battery in pedometer.

  

 

       

 

 

       

Plastic strip

Battery Door

 C 

 Set up

Once  battery  is  activated,  the  pedometer  automatically 
enters the setting mode.  

 TIP 

 To enter manually at any time after that, press 

SET

.

To toggle between different setting modes:

1.  Press 

SET

 once to enter setting mode.  

SETUP 

 

 

will be displayed.

Within  each  setting  (Stride,  Weight,  Time,  Alarm  and 
Beep tone), there are several items to set.  To skip to the 
next setting, press 

SET

, or wait 3 seconds for the unit to 

automatically move to the next item on the list.

To change values for each setting:

1.  Press 

DISP 

 or 

MEM 

  .

 NOTE 

 The pedometer automatically moves to the next 

setting  within  3  seconds.    If  there  is  no  input  /  change 
made, the unit will use the default value.

2.  Wait 3 seconds to move to next item.
 

Repeat steps 1-2 above for all items.

The settings order is:
Display

 

 

Setting Title

 

Items to set

 

 

 

(Press 

DISP

 

  or  

 

 

 

MEM

 

 )

  

 

Main Setting 

 

 

 

 

 

 

 

 

 

 

 

 

Stride 

Measurement unit  

 

 

 

(cm / in)

 

 

 

Length

 

 

 

 

 

 

Weight 

Measurement unit  

 

 

 

(lb / kg)

 

 

 

Weight

 

 

 

 

 

 

 

 

Time 

12 / 24 hour format

 

 

 

Hour

 

 

 

Minute

 

 

 

 

 

 

Alarm 

Alarm On / Off

 

 

 

Hour (Only if Alarm  

 

 

 

ON has been

 

 

 

selected)

 

 

 

Minute (Only if  

 

 

 

Alarm ON has been  

 

 

 

selected)

 

 

Beep Tone 

On / Off

 

 

 

 

 

 

 

 

 

 

Final display 

 

 

 

 

 D 

  Replace batteries

The pedometer uses a CR2032 3V battery, which has 
already been installed.
When 

 is displayed, battery power is low. 

1.  Remove the pedometer from the belt clip.
2.  Open the battery compartment lid, located at the  
 

back of the pedometer by removing the screw.

3.  Insert the battery, matching the polarities with  
 

the positive pole facing up.

4.  Replace the lid by screwing it back into place.
 

After each battery change, remember to set up  

 

the unit again (refer to Section C Set Up above)

SETUP INSTRUCTION GUIDE

SET

SET

SET

SET

SET

SET

P/N:300102429-00003-10

Reviews: