Included components
ASSEMBLE WITH CARE!
Pangard II
Polyester Powdercoat is a strong, long-lasting finish. To
protect this finish during assembly, place unwrapped powdercoated parts on packaging foam or
other non-marring surface. Do not place or slide powdercoated parts on concrete or other hard or
textured surface – this will damage the finish causing rust to occur. Use touch-up paint on any
gouges in the finish caused by assembly tools.
Landscape Forms is not responsible for site preparation and footings. Footing
recommendations are included in these instructions.
LIGHTING LAYOUT RECOMMENDATIONS:
Refer to the Typology Path Light product data sheet at
for
more information.
Fig. 1 – Minimum footing recommendation
Tools Required
•
Safety glasses
•
Screwdrivers
•
Wiring tools and connectors
•
Masonry drill, with Ø1/2” bit
•
Compressed air and wire brush
•
Epoxy anchoring system for concrete
•
1/2” socket wrench
•
5/32” hex key
Installation Guide
Typology
Path Light
www.landscapeforms.com Ph: 800.521.2546
Date: March 21, 2022
Page 1 of 3
Fig. 2 – Minimum concrete slab size
HEX BOLT AND
WASHER
CONCRETE
ANCHOR
EDGE OR
EXPANSION
JOINT
Fig. 3 – Assemble anchor template
HEX BOLT
WASHER
TEMPLATE
CONCRETE
ANCHOR
Single
Double
4x – 5/16-
18 concrete
anchor
4x – 11/16
OD washer
4x – 5/16-
18 x 1” HEX
BOLT
1x – unit
body
single
1x –
anchor
template
1x – unit
body
double
2x – concrete
panel double
1x – concrete
panel single
1x – concrete
panel single
Included hardware
Fig. 5 – Recommended
setback from sidewalk
SIDEWALK
Fig. 4 – Proper orientation
of conduit
CONDUIT
FRONT OF
LIGHT
