915681-00 Rev A
MSO-3M Instruction Sheet
Page 1 of 2
OVERVIEW
Included with the MSO-3M cable shipment are the following:
•
Qty 1 - 18 channel 3M connector cable
•
Qty 1 – MSO-3M Instruction sheet (this document)
OPERATING ENVIRONMENT
Before using the MSO-3M cable, ensure that its operating environment will be maintained within
these parameters:
Temperature:
5 to 40
o
C
Humidity: < 80% RH (non-condensing)
SAFETY REQUIREMENTS
CAUTION
To avoid personal injury or damage to the MSO-3M or any equipment connected to it, review and
comply with the following safety precautions.
•
Use only as intended.
The MSO-3M cable is intended to be used only with LeCroy
MS-250, MS-500 or MS-500-36 Mixed Signal Oscilloscope options. Use of the
MSO-3M and/or the equipment it is connected to in a manner other than specified may
impair the protection mechanisms.
•
Connect and disconnect properly
. Avoid damage to cables thru excessive bending.
When disconnecting the MSO-3M cable from the MS-250, MS-500, MS-500-36 or
Device Under Test NEVER pull on the blue wires, pull only the black plastic housing.
•
Do not use in wet/damp or explosive atmospheres.
•
For indoor use only.
The MSO-3M cable and associated test equipment is intended
for indoor use and should be operated in a clean, dry, environment.
•
Do not operate with suspected failures.
Do not use the product if any part is
damaged. All maintenance should be referred to qualified service personnel.
BASIC OPERATION
Connecting the MSO-3M to the MS-250 or MS-500
•
Connect the end of the cable labeled D0 – D17 to the corresponding input of the MS-250
or MS-500 labeled D0 – D17
and fasten thumb screws
Note: MS-500 can be operated in 36 channel mode by using two MS-3M cables however both
MSO-3M cables will be labeled D0-D17.
www.
.com
information@itm.com
1.800.561.8187
