Remote Control SH-12 LEFFER
User Manual
HANDHELD TRANSCEIVER: SHT12LEFFER / 01240.98
TRANSCEIVER:
SHR12LEFFER / 01272.98
This device complies with part 15 of the FCC Rules and with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void th user´s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
1. General
The remote control is able to drive up to 6 DC motors in order to lock or unlock drill heads. With push buttons of the
handheld transmitter the lock- or unlock function may be started. The activated function is normally stopped by limit
switches.
The state of each limit switch and also the completed function in general is displayed at the handheld transmitter by
LEDs.
An activated lock- or unlock function may be stopped at any time with the Stop function.
