NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE
FIREPLACE KITS
AND ACCESSORIES
INSTALLATION INSTRUCTIONS FOR LENNOX'S SYMPHONY SERIES BI-FOLD GLASS DOORS
MODELS 38LSBF, 38LSBF-B, 43LSBF, 43LSBF-B, 48LSBF, 48LSBF-B
BI-FOLD GLASS DOORS
750,108M
07/2001
Lennox's Estate 48 fireplace may be fitted with either 48LSBF or
48LSBF-B doors.
Use Lennox's 38LSBF and 43LSBF with the LBR and LBC 3824 appli-
ances and the LBR and LBC 4324 appliances respectively.
Lennox's Symphony series Bi-Fold doors come standard with a decora-
tor satin black finish and may be purchased in a polished brass finish
designated by the -B suffix to the model/size number.
Do not alter or modify these door assemblies or a fireplace malfunction
or a fire hazard may result.
These glass door assemblies have been tested and listed by Warnock
Hersey Inc.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
GENERAL INFORMATION
This door assembly consists of a right and left bi-fold glass panel
assembly factory mounted within an outer frame. Door handles are
attached in place. There are no additional parts that are required to
install the Symphony Series door, all required hardware is provided.
Fireplaces listed on the front page of this document, have been designed
to accept the Symphony Series doors with minimum effort.
TOOLS REQUIRED
Medium Phillips Screwdriver
Hammer
Electric Drill
⁵⁄₆₄
" Diameter Drill Bit
Note: In most cases the door frame will not install completely flush with
the appliance front face. The frame will usually protrude from the opening
approximately an 1/8 of an inch.
Model LBR and LBC Fireplaces
Note: The Center Wedge Clip located inside the track in the center of the
door frame indicates the bottom of the frame. It is important that the
frame be installed with the correct side up to insure smooth operation
of the doors.
Step 1. Position the door support bracket along the lower front face of
the appliance ash lip, oriented as shown (
see Figure 1 ) (DO NOT affix the
door support bracket to the outer front face of the appliance). Using the
two (2) self tapping screws provided, secure the door support bracket
to the front of the ash lip.
Step 2. Position the frame in the fireplace opening on top of the door
support bracket, centering left and right. Mark the fireplace at each hole
in the side panels.
Note: The frame is provided with two sets of holes allowing for near "Flush
Face" installation and "Protruding" installations that may be particularly
useful in certain finish applications. In most cases the door frame will not
install completely flush with the appliance front face. The frame will
usually protrude from the opening approximately an 1/8 of an inch.
