Learn Mode
To add IBDK-01 into Z-Wave network or to remove it from Z-Wave network,
IBDK-01 should be put into learn mode after Z-Wave controller is put into
“Add(Inclusion)” or “Remove(Exclusion)” mode.
(Refer to corresponding manual to learn how to put the Z-Wave controller into
Add/Remove mode.)
IBDI-01 is entering Z-
Wave “Learn Mode” by following steps
1.
Open battery cover
2.
Press and hold the button there
3.
LED is turned on after 5 seconds
4.
Release the button when the LED is turned on
Using devices from multiple in one network
This product can be operated in any Z-Wave network with other Z-Wave
certified devices from other manufacturers. All non-battery operated nodes
within the network will act as repeaters regardless of vendor to increase
reliability of the network.
Association Group
IBDK-01 supports one Association group of Group identifier 1 and five devices
can be associated with this group.
“Device Reset Locally”, “Central Scene”, “Battery” reports are sent to these
associated devices.
Factory Reset
IBDK-01 can be reset to its factory default settings by following steps.
However, please use this procedure only when the network primary controller is
missing or otherwise inoperable.
1.
Open battery cover.
2.
Press and hold the button there
3.
LED is turned on after 5 seconds. Keep holding.
4.
LET starts blinking after 10 seconds.
5.
Release the button when the LED blinks
S2 Security
