light-for-me
Video Light 3XML
User’s manual
Please read the Video Light 3XML user’s manual carefully before the first use and keep it
for future reference.
Scuba diving is treated as an extreme sport and requires proper training and certification.
Using scuba equipment, Video Light 3XML included, by an untrained and inexperienced
person without proper certification may cause health damage and even risk of death.
light-for-me Video Light 3XML:
- up to 3600 lumens
- 120 degrees
- 6300 K
- made from anodised aluminium
- built-in Li-Ion protected battery pack
- burn time: 60min
- simple charging
- dedicated Li-Ion charger included
- clamp with ball included
Switching on/off
To switch the light on, twist the body to the head right (clockwise direction)
until the light goes on. To switch the light off, twist the body left (anti-
clockwise direction) to the first moment when the light goes off and stop.
Should you continue to twist the body off the head, you may flood the light
and that may cause irreversible damage to the product.
Make yourself familiar with switching the light on/off before entering the
water. Do not leave the light switched on on the surface for more than 5
seconds.
Do not point the light directly into your or anyone else’s eyes.
Charging
To charge Video Light 3XML untwist the body from the head.
Twist the body of the light to the charging port (round plug with spring - see
photo below).
Do not
twist the charging port and cable as this may cause
damage to the charger cable and its connection with the charging port.
Then plug the charger to the mains.
Depending on the charger type:
* The red POWER diode will appear on the charger and then it will do a
self-test - three green diodes start flashing one by one. After that the
charger will start charging process indicating at the same time the charge
level of the battery pack. Each solid green diode indicates 33% of the
battery pack charged.
* The red POWER / CHARGING diode will light on the charger. After the
charging process has finished, the green diode goes on.
After the charging process has finished, unplug the charger from the mains
and disconnect it from the Video Light body (untwist the body - do not twist
the charging port and cable). Do not keep the light on charge after the
charging processed has finished.
Video Light 3XML Maintenance
Before each dive check the overall condition of the Video Light 3XML.
Check orings that seal the Video Light Body to the head. Torn, cut or
damaged orings should be replaced with new ones as they may cause
flooding of the light.
www.light-for-me.com
