_________________
tel.800-670-8137 www. lightwavesconcept .com
INSTALLATION INSTRUCTIONS
For Flex II
300 Watt Magnetic
Transformer - Wall
Important Safety Instructions
When installing or using this track system, basic safety precau-
tions should always be followed, including the following:
A] Read all instructions.
B] This track system must be installed utilizing the canopy and
connectors for mounting over a ceiling outlet box.
C] Do not install this track in damp or wet locations.
D] Do not install any part of a track system less than 5 feet above
the floor.
E] Do not install any fixture assembly closer than 6 inches from
any curtain, or similar combustible material.
F] Use MR16 type lamps, 50-watt maximum with 300-watt trans-
former.
G] Disconnect electrical power before adding to or changing the
configuration of the track.
H] Do not attempt to power anything other than Flex II Track
Lighting fixtures on the track. To reduce the risk of fire and electric
shock, do not attempt to connect power tools, extension cords,
appliances and the like to the track.
I] If you plan to install a dimmer, do so after the Flex II system
has been installed to reduce the risk of damage to the dimmer.
We recommend using a Lutron magnetic low-voltage dimmer
[SLV600-P]
Transformer
300W
1x
Stems
6x
LiveFeed
1x
10ft Track
1x
Fixtures
5x
Bulbs
5x
Dead Ends
2x
Light Waves
LED Waves
Light Waves
Lighting SuperStore
_________________
tel.800-670-8137 www. lightwavesconcept .com
SAVE THESE INSTRUCTIONS
AND REFER TO THEM WHEN ADDITIONS
TO OR CHANGES IN THE TRACK CONFIGURATION ARE MADE.
_________________
tel.800-670-8137 www. lightwavesconcept .com
Installation Tools
Phillips Screwdriver
Wire Cutter
Drill + Bit
1
2
3
4
6
5
