Images are for illustration only and may differ from components supplied
Link Research Ltd
www.linkres.co.uk
CL140032 Issue 01
LinkHD Quick Start Guide S (44) 1923 474099
Page 1 of 2
Link HD Quick Setup Guide
Connecting the LINK HD
The basic camera system comprises of three main components:-
Link HD Transmitter L1403 (2GHz) L1405 (3GHz)
Link RF Downconverters (Base L3020 for 2GHz, L3050 for 3GHz)
Link HD Receiver/Decoder L2132
Optional components for Camera Control are:-
Link Wireless CCU Interface L1255
Link HD Camera Controller L1420 (this will come factory assembled to the HD Transmitter)
The necessary cables and connectors to setup the basic system are included.
Battery Plates as ordered will come factory assembled to the Transmitter.
Typical connections shown above. Different configurations may be required for different camera
manufacturers, and different camera models..
Initial Setup
-
Connect the components as shown (battery and power connections not shown in diagram)
-
Place the transmitter on the camera battery plate. Connect the Camera SDI /Audio inputs
and, if fitted, the camera control connector. Put power on the components.
-
Note:- If the components are setup near each other (on a bench or in a room), then the
signals may cause overload and signal may have to be attenuated to get operation.
-
For more detailed information on the system please read the manual. Check with Link
Support for latest software upgrades
Basic Menu Navigation
