Living Earth Crafts © 2013 All Rights Reserved
REV_0306_13_1100
Step 1
Begin by selecting level floor location for installation. Note: For the seat to slide back and recline, the
back edge of the tub must be installed at least 49.5 inches from the wall; the center of the drain
should be a minimum of 62 inches from the wall. (see diagram A)
Step 2
Remove back access panel of tub.
Step 3
Position tub on desired spot and bolt to floor using four (4) holes provided on tub base (3/8” bolts
recommended). (see diagram B)
Step 4
Connect waste line, hot and cold water supplies. (see diagram C)
Step 5
Test plumbing for leaks.
Step 6
Replace access panel.
Step 7
Position chair directly behind tub. Chair should move freely in line over tub. Note: Back edge of chair
base must be a minimum of 12 inches from wall in order to recline (see accompanying
diagram/specifications).
5th Avenue PediLounge™
5
PediLounge
INSTALLATION INSTRUCTIONS
DO NOT move chair sideways on wheels. Wheels were designed to move back/forward
in line with wheel direction. To move chair sideways, chair must be lifted by chair arms
by a minimum of two people and lowered on desired spot. Doing otherwise can cause
damage to the chair and void its warranty.
IMPORTANT NOTE
Failure to comply with federal, state, or local codes and ordinances could result in the
voiding of product warranty as well as potential injury and flooding. A licensed
plumber should make all utility connections. All plumbing connections must conform
to local codes. Water temperature/pressure should not exceed local regulations.
IMPORTANT WARNINGS
62”
12”
A
Wall
Drain
C
Water Out
Cold Water
Hot Water
Drain Valve
B
Tub Underside
Hole Locations
All manuals and user guides at all-guides.com
all-guides.com
