The Model Verifact™ A is an omni-directional, low
impedance, electret condenser microphone with built-in
preamp. It can pick up normal sounds approximately
15 ft. away, or within a 30 ft. diameter circle. Verifact™
A produces line level output (0 dB @ 1000
W
) and can
be located up to 1,000’ from the Louroe base station. It
is primarily designed for ceiling mounting but can also
be installed on any type of flat surface. The Verifact™
A is compatible with all Louroe Audio Base Stations or
Louroe Audio Interface Adapters.
PAGE 1 OF 4
NOTE:
Verifact™ A Microphone is NOT recommended
for outdoor use or in areas with high moisture
content.
VERIFACT
™
A
Microphone
Housing and
pre-amp
Microphone
Element
2 Conductor
shielded
cable, 22
gauge with a 24 gauge drain
wire.
NOTE:
Unshielded cable is not
satisfactory for audio
systems.
WIRING REQUIREMENTS
DESCRIPTION
SPECIFICATIONS
Sensitivity
(microphone & preamp)
Frequency response
Output
Current drain
80 dB SPL input
provides 0.254V rms
40 Hz to 15 kHz ± 1 dB
4 mA
Supply voltage
12 Vdc
Microphone housing
High impact ABS
Dimensions US
Weight
4”
"
dia x 1 ½ H
(10cm dia x 3.8cm H)
0.5 Lb (0.2 Kg)
Line Level (0 dB @ 1000
Ω
)
metric
VERIFACT
™
A
AUDIO MONITORING SYSTEM
INSTALLATION AND OPERATING INSTRUCTIONS
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
/ www.louroe.com
techsupport@louroe.com
®
A_mic-inst_4/11
