MAT-1 Battery Replacement Tool Kit, Rev A
1
MAT-1 Battery Replacement Tool Kit
The
MAT-1 Battery Replacement Tool Kit
contains the items that are required to
replace the battery in a MAT-1 Data
Logger. The kit also includes one
replacement battery to get you started.
Additional batteries may be purchased
separately.
Package Contents
•
Circuit Board Holding Tool
•
3/32” Hex Driver
•
Replacement “A” size lithium battery
Caution
: This logger is sensitive to static electricity when removed from the logger housing. Hold the
circuit board by the edges and avoid working on indoor carpet or in other static prone environments.
Instructions
1.
Remove the end cap of the logger, connect a USB cable and use MAT Logger Commander to
stop the logger. Failure to stop a running logger will result in data loss.
2.
Slide the Circuit Board Holding Tool into the end of the logger. Aligning the slot in the tool with
the circuit board.
3.
Locate the two hex screws inside the logger and insert the hex driver into one of them.
4.
Loosen, but do not remove the screw. Repeat on the other side.
5.
The board should now be loose within the housing. Gently tap the housing and slide the circuit
board and battery out of the logger.
Align
Circuit Board Holding
Tool
and insert fully into
logger housing.
Carefully use the
Hex Driver
to
loosen set screws located
inside the logger (not shown).
Battery
Desiccants (2)
USB Port
Circuit Board Holder
Set Screws (2)
Battery Connector
