LP TENT Airtents Assembly Instructions Download

Page: 1 / 4

2. Installation Of The Top

Pieces

1. Opening The Air Tent

Frame

Top

Pump Adaptor

Carrying Bags

Pump

Roll out the frame so that the 2

Blue

marked D rings are on top

in the middle of the X pattern. The air valves (

) should

be pointing to the ground.

Unfold and tie the center of the top to the 2

Blue

marked D rings in the

center of the frame. Place the top on the frame and
secure the Velcro straps (

) from 3 of the arms to the

Blue

marked D

rings (

) on 3 of the frame legs.

Be sure there are no twists in the legs

Be sure that all the vents are in locked close position and caps are on tight.

AIR

Assembly Instructions for Airtents

Summary of Contents for Airtents

Page 1: ...valves 2 should be pointing to the ground Unfold and tie the center of the top to the 2 Blue marked D rings in the center of the frame Place the top on the frame and secure the Velcro straps 1 from 3...

Page 2: ...r to the end of the pump hose Remove the cap from the valve 1 directly below the emergency release valve 2 Attach the vent to the valve 1 to inflate the tent Pump the frame with air until it s full 1...

Page 3: ...be if fully inflated When the frame is almost full and starting to lift you ll need to get under the center and push up to get the tent to lift As soon as the tent lifts turn off the pump and check th...

Page 4: ...and place the stakes at an approximate distance of 3ft from the legs Advised Securing Procedures Rope and Peg Kit system for securing the tent Water Weight Bag Attaches to the base of the airtent fram...