SY 220 / SY 250 Light Module Installation Instructions
BEFORE YOU START
Parts Supplied
www.Lumishore.com
45-0076 - Rev 1
Lumishore UK Unit 2, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | Info@Lumishore.com
Lumishore USA 7137 24TH Court East Sarasota, Florida 34243 | (941) 405-3302 | Sales@LumishoreUSA.com
SY 220 / SY 250 Series Underwater lights
INSTALLATION OF A LIGHT MODULE
TO THE WELD-IN FLANGE
(SUPRA AND EOS MODELS)
Please read ALL the following pages before attempting
installation to ensure complete understanding of what is required
This document describes the recommended method for installing the light module of Lumishore SY 220 / SY 250 series lights in order to
provide a water tight seal between the flange (previously welded in) and the light.
CAUTION
•
DO NOT use any adhesives, sealants, gaskets, cleaning agents or chemicals other than those specified
in this manual. Using any materials in the installation that are not specified in this manual will invalidate the
warranty
•
The light module is a factory sealed unit. DO NOT attempt to take the light apart or remove any bolts
from the light
•
The flange and the light must be electrically isolated - ensure the check described in the manual is
carried out
•
The flange / light installation must be pressure checked to ensure it has been installed correctly.
Ensure this check is carried out as specified
SY 220 / SY 250
100 Degree
Light and
Cable
Light Securing Bolt
with Washer and
Insulating Washer
(x7)
1
SY 220 / SY 250
60 Degree
Light and
Cable
( OR )
