EC10•40 Technical Manual
EC10•40 Technical Manual
CHARACTERISTICS
The EuroLine series was specially developed for safes which have two thru holes,
100 mm apart. The plastic housing of the EuroLine Entry unit combines an alpha-
numeric membrane keypad with a pull handle (metal). The 8x8 mm square shaft of
the pull handle drives either the lock or a boltwork. This unit requires a separate
battery box. Battery terminals in the front of the keypad are provided in case
batteries are completely depleted. Cable length is approximately 30 cm.
DIMENSIONS / MOUNTING INSTRUCTION
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The
spindle hole should be maximum
Ø
13 mm. Both holes must be deburred well to
avoid damage.
Cut the 8 mm square shaft to an
appropriate length. Make sure the
shaft drives the lock or the boltwork
not just with the tip. Affix the shaft
with the provided screw in the
handle and cover the screw with
the label.
Adjust position and mount the entry unit with M4 flathead screws.
Push the shaft as shown above into the boltwork
. Lock and boltwork must be in
the “OPEN” position.
Vlijtstraat 40, NL-7005 BN Doetinchem
Tel: +31 314 376 876 Fax: +31 314 376 878
www.m-locks.com / info@m-locks.com
