background image

MB197UC, -BK, -BL, -FBK, -GRAY, -LG, -OR, -WT, -YE 

 

Rev. 12/22/15

OWNER'S MANUAL

MB197UC, -BK, -BL, -FBK, 

-GRAY, -LG, -OR, -WT, -YE 

3 DRAWER

DELUXE UTILITY CART

• Read and follow all instructions in User's Manual
• Do not load carts beyond rated capacity: 
Maximum Total Net Load   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . 500-Lbs .
Top and Bottom Shelf  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . 150-Lbs . each
Top Two Drawers  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . 100-Lbs . each
Bottom Drawer .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . 200-Lbs .
Sliding Work Surface (closed)  .  .  .  .  .  .  .  .  .  .  .  .  .  .  . 200-Lbs .
Sliding Work Surface (fully extended)  .  .  .  .  .  .  .  .  .  .  . 50-Lbs .
PLEASE NOTE: Loading cart beyond rated capacity may cause 
structural  damage  to  the  cart  as  well  as  personal  and  /or  
property  damage .  Please  educate  your  customers  to  the 
"dangers of overloading"

• Lock lid and drawers before moving • Apply brake on locking 
casters anytime cart is in place • Do not pull cart . Push from 
handle on end to move • Units can tip or fall causing damage or 
personal injury • Cart is designed to roll easily on flat surfaces 
and should not be used on  uneven or inclined surfaces • Do not 
open more than one loaded drawer at a time • Do not stand on 
or step in drawers • Keep children away from unit • Wear gloves 
when  lifting  edges  •  This  product  may  contain  one  or  more 
chemicals  known  to  the  State  of  California  to  cause  cancer  
and  birth  defects  or  other  reproductive  harm .  Wash hands  

thoroughly after handling • Failure to heed these warnings may 

result in personal injury and/or property damage 

WARNING

© 2015 Mac Tools

T40 Torx Bolt (M8) 32 pcs. (1A)

T40 Torx Bolt (M8) 8pcs. (1B)

Hex Bolt, Washer, and Lock  

Washer (M8 x 20)  16 pcs. (8)

HARDWARE SPECIFICATIONS

TOOLS NEEDED FOR ASSEMBLy:

• T40 Torx Driver or Torx Key
• 13mm Combination Wrench
• Socket or Universal Socket
• 4" Extension and Ratchet

Summary of Contents for MB197UC






Reviews: