1/3
LH71 Change of display resolution (polarity)
Press
key of the axis you want to change and select
the measurement unit resolution.
When you have made your selection, press
key to save your settings.
Press key two or three times while the display is .
The display will be
(measurement unit resolution).
Press key to check the current length measurement unit resolution.
Press key once while the display is .
The display will be (measurement unit resolution).
Press key to check the current measurement unit resolution.
LH71 Change of display resolution (polarity)
Ver.1 (2021.1) CS&S
* If you do not know the output resolution of the measurement unit, refer to the separate "Initial setup manual".
About 2 sec
For LH71-1, LH71-2
For LH71-3
Press
key once to automatically switch to advanced settings mode.
The display will be
.
Press
key, the display becomes the normal display.
Display of measurement unit resolution (LH71-3)
Purpose of change
Operation
Explanation
Change the measurement unit resolution
Change the length measurement unit resolution in
the basic settings. And check the display resolution
in the detailed settings.
Change the polarity for each input axis
while using the addition function
Change the selection of addition display in the basic
settings
Change the display resolution
Change the display resolution in the detailed
settings
Change the display polarity
(Counting direction is reversed)
Change the display resolution in the detailed
settings
Diameter display (double count value)
Change to diameter display with display resolution
in the detailed settings
Detailed settings
⇒
Display resolution
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Diameter display
LH71-3
The operation method for changing the display resolution differs depending on the purpose and conditions of the change.
Select the purpose and conditions to be changed from the table below and perform the operation.
Basic setting
⇒
Measurement unit resolution
⇒
Change
Basic settings
⇒
Addition display
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Change polarity
Standard
Expansion
Extended key
Selection of measurement
unit resolution
Set to basic setting mode.
Turn key “ON” while the AC adapter is energized.
Press and hold key for 3 seconds after the lamp changes from blinking to off.
Basic setting
⇒
Measurement unit resolution
⇒
Change
About 2 sec
①
②
②
③
④
⑤
Switch from basic settings to normal count mode.
Press
key once and the display will change to
.
Press
key once and the display will change to
.
Input 1
Input 2
Input 3
Power ON
