tDynamo Stand Overview
tDynamo secure card reader authenticator has an optional docking stand.
The docking stand can be used in a locked or unlocked state, securely
mounted or not mounted, and in combinations of these options. In the
unlocked state, whether securely mounted or not, it allows for quick grab-
and-go and convenient drop-in charging of tDynamo between handheld
sessions.
Major Components
Top Center: Stand with integrated USB cable; Left: Docking Stand Key
(side and bottom views); center: Countertop Mounting Knob; right: and
Countertop Mounting Bolt
How to Mount the Docking Stand
To mount the docking stand to a countertop, follow these steps:
1. Determine where the docking stand should be placed: Factors to
consider include cable length, cardholder and operator ergonomics,
and access for cleaning and repair. If the docking stand will be used
for charging in handheld operations, unobstructed removal is also a
consideration.
2. Open the protective cap over the mounting hole on the base of the
docking stand.
3. Place the docking stand at the desired location and mark the center of
the mounting hole on the countertop, then set the docking stand aside.
4. Drill a ¼” hole all the way through the countertop.
5. Line up the hole in the stand over the hole in the countertop.
6. Thread the included bolt through docking stand’s mounting hole and
the countertop hole.
7. Fasten the included knob to the bolt and tighten it.
8. Close the docking stand’s protective cap.
9. Connect the docking stand’s USB cable to the host.
tDynamo Docking Stand - PN 21079820
Secure Card Reader Authenticator
Quick Installation Guide
Components and Mounting
MagTek
®
Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 651-415-6800 | f 562-546-6301 | www.magtek.com
