background image

HR3550C

SPECIFICATIONS
Model

HR3550C

Capacities

Tungsten-carbide tipped bit .................................................................................................................. 35 mm
Core bit ................................................................................................................................................. 90 mm
Wood ................................................................................................................................................... 30 mm
Steel ..................................................................................................................................................... 13 mm

No load speed (min

-1

) ......................................................................................................................... 360 – 720

Blows per minute .......................................................................................................................... 1,650 – 3,300
Overall length ......................................................................................................................................... 420 mm
Net weight ................................................................................................................................................. 4.9 kg

• Due to our continuing program of research and development, the specifications herein are subject to change

without notice.

• Note: Specifications may differ from country to country.

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets without earth wire.

Rotary Hammer

HR3550C (cover) (’100. 8. 29)

Summary of Contents for HR3550C













Reviews: