background image

1. Remove current hot date coder

1.1

 Stop the line, power off the hot date 

coder. 

If using air-driven hot date coder, shut  

off air supply and disconnect air pipe.

1.2

 Remove packaging material from 

the coder bracket area.

1.4

 Using wider end of 

Allen key

 

from Marsh 241D box, remove the  

2 bracket mounting screws.

1.5 

Remove the bracket locking handle.

1.6

 Remove existing platen rubber

from bracket, along with any platen 

rubber clamps.

1.3

 Undo connector on hot date coder.

© 2020 All rights reserved. We reserve the right to alter design and/or specifications without notice.

Marsh 241D Installation Guide

Summary of Contents for 241D

Page 1: ... coder bracket area 1 4 Using wider end of Allen key a from Marsh 241D box remove the 2 bracket mounting screws 1 5 Remove the bracket locking handle 1 6 Remove existing platen rubber from bracket along with any platen rubber clamps 1 3 Undo connector on hot date coder 2020 All rights reserved We reserve the right to alter design and or specifications without notice Marsh 241D Installation Guide ...

Page 2: ...ive backed platen rubber b in place of old platen rubber 2 2 Fit Marsh 241D to bracket clamp using the 2 new mounting screws c from the Marsh 241D box Tighten the 2 screws 3 3 Push the printer towards the platen rubber b to make sure the gap setting tool d is pressing against and in square alignment with the platen rubber 2020 All rights reserved We reserve the right to alter design and or specific...

Page 3: ... Wind on the ribbon by hand to ensure it is tight 3 9b If it does NOT slide the bracket locking handle is not needed Unscrew the top mounting screw turn ONLY slide printer into desired position and re tighten the top mounting screw 3 6 IMPORTANT Check the gap setting tool d has remained in contact with and is square to the platen rubber b 3 9 Push on bracket clamp to see if it is free to slide alo...

Page 4: ...ontrol box sitting on top of the VFFS control cabinet Unplug I O connector from the hot date coder control box 4 5 Unpack Marsh 241D power supply unit f and place it in place of the hot date coder control box 4 8 The Marsh 241D will power up with a flashing light sequence and it will wind a small amount of ribbon 4 3 Connect I O connector to the I O extension cable e 4 6 Connect the 24VDC cable fr...

Reviews: