background image

© 2015 Johnson Health Tech. All Rights Reserved. Specifications subject to change without notice.

Rev 1.1

MAGNUM  SERIES

MG-MR690-04 / MEGA HALF RACK

MAINTENANCE CHECKLIST

ACTION

FREQUENCY

Clean Upholstery *

Daily

Inspect Cables

Daily

Clean Guide Rods

Monthly

Inspect Hardware

Monthly

Inspect Frame

Bi-Annually

Clean Machine

As Needed

Clean Grips *

As Needed

Lubricate Guide Rods †

As Needed

* Upholstery & Grips should be cleaned with a mild soap and water or 

a non-ammonia based cleaner.

† Guide rods should be lubricated with Teflon based lubricant. Apply the 

lubricant to a cotton cloth and then apply up and down the guide rods.

PRODUCT SPECIFICATIONS

TECH SPECS

Maximum User Weight

181.5 kg / 400 lbs. 

Maximum Training Weight

408.5 kg / 900 lbs. 

Product Weight

259 kg / 570 lbs.

Overall Dimensions

(L x W x H)*

170.5 x 207 x 246.5 cm /

67” x 81.5” x 97”

Weight Horn Diameter  

(Weight Plate Storage)

47.63 mm / 1.875”

* Ensure a minimum clearance width of 0.6 meters (24”) for access to 

and passage around MATRIX strength equipment. Please note, 0.91 

meters (36”) is the ADA recommended clearance width for individuals 

in wheelchairs.

WARRANTY

For North America, please visit 

www.matrixfitness.com  

for warranty information along with warranty exclusions  

and limitations.

PROPER USAGE

1.  Do not exceed weight capacity of this 

equipment.

2.  If applicable, set safety stops to 

appropriate height.

3.  If applicable, adjust seat pads, leg 

pads, foot pads, range of motion 

adjustment, or any other type 

of adjustment mechanisms to a 

comfortable start position. Make 

certain that the adjusting mechanism is 

fully engaged to prevent unintentional 

movement and to avoid injury.

4.  Sit on bench (if applicable) and get into 

appropriate position for exercise.

5.  Exercise using no more weight than 

you can safely lift and control.

6.  In a controlled manner, perform 

exercise.

7.  Return weight to its fully-supported 

start position.

Summary of Contents for MG-MR690-04

Page 1: ...Weight Horn Diameter Weight Plate Storage 47 63 mm 1 875 Ensure a minimum clearance width of 0 6 meters 24 for access to and passage around MATRIX strength equipment Please note 0 91 meters 36 is the ADA recommended clearance width for individuals in wheelchairs WARRANTY For North America please visit www matrixfitness com for warranty information along with warranty exclusions and limitations PRO...

Page 2: ... use of the equipment by a person responsible for their safety 3 All warnings and instructions should be read and proper instruction obtained prior to use Use this equipment for its intended purpose ONLY 4 Inspect the machine before use DO NOT use machine if it appears damaged or inoperable 5 Do not exceed weight capacity of this equipment 6 ALWAYS use a spotter if using free weights 7 Balance the...

Page 3: ...tach the spotter stands to the bases and torque all bolts to 30 ft lbs 2 Using 4 3 8 16 x 1 bolts and 4 3 8 washers attach base support to bases Do not tighten bolts 3 Attach each upright to the base using 8 3 8 16 x 1 bolts and 8 3 8 washers Do not tighten bolts 4 Weight storage Bottom Using 4 3 8 16 x 1 bolts and 4 3 8 washers attach the bottom of the weight storage to the bases Do not tighten b...

Page 4: ...x 1 bolts and 8 3 8 washers attach the upright chin bar supports between the rear 2 uprights Do not tighten bolts 7 Chin bar Using 4 3 8 16 x 1 bolts 4 3 8 washers 4 1 2 13 x 4 1 2 bolts 8 7 16 washers and 4 1 2 13 nuts attach the chin bar between the top upright supports Do not tighten bolts 8 Tighten bolts Starting with the bottom of the uprights and working up to the top of the machine tighten ...

Reviews: