background image

IMPORTANT CARE AND CLEANING INSTRUCTIONS 

Memphis Shades Windshields and Lowers are made of 
Lucite® acrylic, and will last for years with proper care. 
Clean your windshield with plenty of soapy water — mild 
dishwashing liquid is best — and a soft cotton cloth. Use your 
bare hand to feel and dislodge bugs, or cover with a wet soapy 
towel and let it soak. Don't use paper towels and don't scrape 
with anything. Small scratches can be removed with NOVUS 
# 2. 
NEVER use any glass cleaning products, petroleum based 
chemicals, or cleaning agents with ammonia, bleach or any 
other harsh chemicals. This includes (but not limited to) 
RainX, brake fluid, acetone, paint thinner, benzene and 
gasoline. "If it hurts your nose, it will hurt the plastic." 

 
Glass cleansing agents will cause severe damage 
to your windshield, and will void your warranty. 

 

Additional tools required that are not included in this kit. 
7/16" or 11mm Wrench. 
 
1.

Cover gas tank and front fender with towels to avoid 

damage during installation. 
 

2. Install the two mounting plates onto the windshield, using 
the bottom and third bolt up. Leave the nylon washers off. 
The small tab goes to the bottom, big one at the top. 

Tabs 

point in towards the Headlight. 

(see fig. 1) 

 
3. Slip the windshield mounting plates and windshield onto 
the fork clamps, (see figure 2 and 3) and secure the left and 
right side locking mechanism. 
 
4. Adjust the height, angle and alignment of the windshield 
and tighten 

ALL 

bolts. 

 

Note: This is a detachable windshield, ALWAYS make sure 
the Locking Mechanism is Fully Engaged after installing 
the windshield!  (see figure 3)

 

NOTE: 

 At certain times of the day the Sunlight can reflect 

off the curvature of a windshield and cause extreme heat 
build-up on motorcycle instruments and instrument panel. 
Take care when parking. Park facing the sun, place an opaque 
object over the instruments or adjust the windshield to avoid 
reflections. 

Fig. 1 

Fig.

 

2

 

MOUNTING INSTRUCTIONS 

MEM8877 01-02-08

 

First Bolt 

Third 
Bolt 

Read and follow these directions carefully. 

During installation, make sure that the windshield and hard-
ware do not interfere with any cables or wiring when the forks 
are turned all the way in either direction. Also make sure, 
through the full range of adjustment, that the windshield and 
hardware do not hit the tank. 

 

This is a detachable windshield, ALWAYS make sure the 
Locking Mechanism is Fully Engaged after installing the 
windshield! 

The improper installation of this kit and related compo-
nents could result in serious injury or death.  

 2320-0039 FATS/SLIMS DETACHABLE PLATE ONLY MOUNTING KIT 

HD 06-07 DYNA WIDE GLIDE

 

Reviews: