BC-DSPX-HD1
I N S T A L L A T I O N I N S T R U C T I O N S
ATTENTION: With the key out of the ignition,
disconnect the negative battery terminal
before installing this product. Ensure that all
installation connections are secure before
cycling the ignition to test this product.
NOTE: Refer also to the instructions included
with the aftermarket radio.
Metra. The World’s Best Kits.
© COPYRIGHT 2022 METRA ELECTRONICS CORPORATION
REV. 1/13/22 INSTBC-DSPX-HD1
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Wire cutter
• Crimp tool and connectors
(example: butt-connectors, bell caps, etc.)
or
• Solder gun, solder, and heat shrink
• Tape
• Zip-ties
TABLE OF CONTENTS
Connections ............................................................2
Installation ......................................................... 3-4
Harley Davidson
DSP
Package with Water
Resistant Enclosure
1998-2013
• Water resistant plug-n-play harness for the BC-DSPX-HD1
• BC-DSPX-HD1 included
• Water resistant enclosure with zip-tie mounts included
• Amplifier, if equipped, does not need to be retained
• All wiring will be done at the radio location
• USB Micro-B updatable
• BC-DSPX-HD1 circuit board
• BC-DSPX-HD1 harness (with gaskets)
• BC-DSPX-HD1 enclosure
• Case
• Cap (with O-ring)
