Operating Instructions for
#87775 MicroLux
®
Miniature Table Saw
Dear Customer:
Designed specifically for rip-cutting narrow strips
from sheet stock and for cross-cutting to close
tolerances, the MicroLux
®
Mini Table Saw will
even cut plastic, thin non-ferrous metals and
printed circuit board with our optional fine-tooth
blades.
State-of-the-Art production and testing procedures
ensure he maximum reliability from your power
tool.
This manual includes:
• Safety instructions
• Installation and operating instructions
• Spare parts list
• Warranty information
Reading this manual will:
• Help you understand the machine’s
operation.
• Avoid malfunctions due to improper
operation.
• Increase the life of the machine.
Always keep this manual close at hand.
Do not operate the machine unless you are
fully familiar with it. Please observe the safety
instructions.
Use only original MicroLux spare parts.
Safety Instructions
Please read the following safety instructions thoroughly and follow them
before starting to work with the machine:
• Always wear safety glasses when operating power tools.
• Keep the work area clean and tidy.
• Do not use electric tools in rain, under wet conditions, near flammable
liquids or gasses.
• Avoid contact with grounded parts, such as pipes, radiators, cookers or
refrigerators.
• Store tools out of the reach of children.
• Do not overload the machine.
• Do not wear loose clothes or jewelry.
• Do not carry the machine by the electric cable.
• Keep the electrical cable away from heat, oil and sharp edges.
If necessary have it replaced by a professional.
• Fasten the machine securely to a work table.
• Replace dull saw blades.
• Clean the machine thoroughly after completing your work.
• Pull out the electric plug before maintaining the machine, before changing
the saw blade or the toothed belt, or when not using the machine.
• Make sure that the machine is switched off before connecting it to the wall
outlet.
• Check the machine for obvious damage before use. Replace defective
parts.
• Repairs in the electrical system should be carried out by a specialist.
• Use only accessories and spare parts which are recommended.
• Use a push stick when working near the saw blade.
MM032218
