Microtek ArtixScan 3200XL, Start Here Manual

     1

Step 2:

Install Software

Start Here

 Installing your Microtek ArtixScan 3200XL

Important

: Do not remove the yellow stickers from your scanner

until you are told to do so.
You must install software before connecting your scanner. 

Always

close any open programs, and turn off Anti-virus utilities before

installing software.

MAC:

A.

Place the 

Adobe DVD 

into a drive, and install

the software. Skip this step if you have a

newer version of Photoshop Elements already

installed on your computer.

B.

Place the 

Microtek Software CD/DVD 

into a

drive, and double-click the 

ScanWizard Pro

installer icon to install ScanWizard Pro first.

C.

Install the remaining software components,

then restart your computer at the end of all

software installation.

NOTE

: After rebooting your Macintosh, the Microtek software

will attempt to locate your scanner on the system. Since this is

your first install and you have not yet connected the scanner,

simply ignore the message that appears and proceed to the next

step.

Step 1:

Unpack Contents

Copyright © 2013   Microtek International, Inc.   http://www.microtek.com
I49-004647 C, September 2013

Unpack your scanner package and

check for major components.

1.  ArtixScan 3200XL (lower base)
2.  USB Cable
3.  Power Cord
4.  Software CDs/DVDs
5.  TMA 1600-III
6.  Black Plate
7.  U-shaped Ruler (Calibration Ruler
8.  4" x 5" Film Template
9.  120 Film Template with Black Plate
10. 35mm Slide Template
11. 35mm Filmstrip Template

1

PC:

A.

Place the 

Adobe DVD 

into a drive, and install

the software. Skip this step if you have a

newer version of Photoshop Elements already

installed on your computer.

B.

Place the 

Microtek Software CD/DVD 

into a

drive, and follow the on-screen instructions to

install the driver and software.

NOTE

: If the Microtek Software Installer screen does not

come up automatically, double-click the following in

succession: “My Computer”; the CD/DVD-ROM icon; then

cdsetup.exe to start the installer program.

C.

Restart your computer at the end of all

software installation.

2

3

4

5

6

7

8

9

10

11