Microtek ArtixScan DI 5230, Start Here Manual

 1

Install Software

Unpack your scanner package and check for

major components.

Copyright © 2013   Microtek International, Inc.   http://www.microtek.com

I49-004886 B, September 2013

Start Here

I

nstalling your Microtek ArtixScan DI 5230/5240/5250/5260 &

ArtixScan TS  540T

3

1. Scanner
2. Hi-Speed USB cable
3. Software CDs/DVDs
4. Document Feed Tray
5. Power adapter
6. Power cord

1

5

2

4

Important:

You must install software before connecting

your scanner. Always close any open programs, and

turn off Anti-virus utilities before installing software.

PC:

A.

Place the 

Microtek Software CD/DVD

into a drive, and follow the on-screen

instructions to install the scanner

driver and software.

B.

Restart your computer at the end of all

software installation.

NOTE

: If the Microtek Software Installer screen

does not come up automatically, double-click the

following in succession: “My Computer”; the CD-

ROM (or DVD-ROM) icon; then cdsetup.exe to

start the installer program.

MAC:

A.

Place the 

Microtek Software CD/DVD

*

into

a drive, and double-click the 

ScanPotter

installer icon to install ScanPotter.

B.

Install the remaining software components,

then restart your computer at the end of all

software installation.

NOTE

: After rebooting your Macintosh, the Microtek

software will attempt to locate your scanner on the

system. Since this is your first install and you have not

yet connected the scanner, simply ignore the message

that appears and proceed to the next step.

* Microtek software CD/DVD (ScanPotter) for the scanner is under

development; therefore, it may not come with your scanner package.
Microtek will provide it to you as soon as possible when it is ready.

Unpack Contents

6