I49-002920, August 2000
Copyright © 2000 Microtek International Inc.
http://www.microtek.com
1. Unpack scanner
Open your scanner package and check major components
while referring to the Packing List. If any item is missing,
contact Microtek Customer Service.
Your Microtek ScanMaker 5700 scanner comes with
FireWire
FireWire
FireWire
FireWire
FireWire and USB
USB
USB
USB
USB built-in interfaces. See the figure below
to locate the different ports at the back panel of the
scanner, including the scanner's accessory port.
2. Unlock the carriage
1. With the scanner turned off, tilt the scanner on its side
to locate the carriage lever safety lock (located at the
bottom left side).
2. Slightly pull the lever towards you until you hear a
“click” which indicates that the scanner carriage has
been unlocked.
Installing and
Getting Started
for the ScanMaker
®
5700
Version
FireWire - Windows 98 SE, Windows Me,
Windows 2000, Mac G3/G4 and iMac DV
USB - Windows 98, Windows Me,
Windows 2000, Mac G3/G4 and iMac
Version
This document provides information on how to install your Microtek scanner on a PC or Mac using the scanner's
FireWire or USB interface and describes the features of the scanning.
Trademarks
Microtek
®
, ScanMaker
®
, ScanWizard
®
, FilmView
TM
are registered trademarks of Microtek International Inc. Macintosh
®
, Apple
®
, FireWire
®
and FireWire logo are trademarks or
registered trademarks of Apple Computer, Inc. Windows
®
is a registered trademark of Microsoft Corporation. All other products or name brands are trademarks of their respective
holders.
Power
switch
Installation for PC and Macintosh
Pull to unlock
carriage safety lock
FireWire ports
Power port
Accessory port
USB port
