1
Step 2:
Install Software
Step 1:
Unpack Contents
Start Here
Installing your Microtek XT6060
Unpack your scanner package and check
for major components.
1. XT6060 scanner
2. Power adapter
3. Power cord
4
.
Software CDs/DVDs
5. Hi-Speed USB cable
Important
: Do not remove the yellow stickers from your scanner
until you are told to do so. You must install software before
connecting your scanner.
Always close any open programs and turn off Anti-virus utilities
before installing software.
Copyright © 2013 Microtek International, Inc. http://www.microtek.com
I49-004759 B, September 2013
1
4
3
2
5
PC:
A.
Place the
Microtek Software CD/DVD
into a drive, and follow the on-screen
instructions to install the scanner
driver and software.
B.
Restart your computer at the end of
all software installation.
NOTE
: If the Microtek Software Installer
screen does not come up automatically,
double-click the following in succession: “My
Computer”; the CD/DVD-ROM icon; then
cdsetup.exe to start the installer program.
MAC:
A.
Place the
Microtek Software CD/DVD
(ScanPotter)
into a drive, and double-
click the
ScanPotter
installer icon to
install ScanPotter.
B.
Install the remaining software
components, then restart your computer
at the end of all software installation.
NOTE
: After rebooting your Macintosh, the
Microtek software will attempt to locate your
scanner on the system. Since this is your first
install and you have not yet connected the
scanner, simply ignore the message that appears
and proceed to the next step.
