OWNER’S MANUAL
FORM: OM-687
164 063D
December 1998
Three-Phase Running Gear (042 886), Weld Cable Holder (043 055),
Cylinder Rack/Lift (043 005), And Stationary Cylinder Rack (042 887)
3
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off welding power source and input disconnect
device.
•
Disconnect input power conductors from
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
•
Keep cylinders away from welding and other
electrical circuits.
•
Never touch cylinder with welding electrode.
•
Always secure cylinder to running gear, wall, or
other stationary support.
FALLING EQUIPMENT can cause injury
and damage.
•
Use proper equipment to lift unit.
•
Use lifting forks long enough to extend out opposite
side of base.
•
Do not put any body part under unit while lifting.
WARNING
miscwarn1.1 5/93
ST-800 213-B
Tools Needed:
3/8, 7/16, 9/16, 5/8 in
Part
No.
Item
No.
Description (Qty)
1
+601 865
Nut, 1/4-20 (2)
2
+602 207
Washer, 1/4 lock (2)
3
+602 241
Washer, 1/4 flat (2)
4
+168 342
Upright Handle (2)
5
+168 341
Front Handle (1)
6
+098 877
Screw, 1/4-20 x 2-1/4 (2)
7
+049 966
Screw, 1/4-20 x 1-1/2 (6)
8
163 444
Shim (2)
9
163 446
Axle (1)
10
604 224
Screw, 1/4-20 x 3/4 (6)
11
602 250
Washer, 13/16 flat (2)
12
121 614
Retaining Ring (2)
13
163 463
Wheel, 10 in (2)
14
601 965
Screw, 3/8-16 x 1 (8)
15
163 442
Caster Mounting Bracket (1)
16
168 247
Caster (2)
17
601 872
Nut, 3/8-16 (8)
18
602 213
Washer, 3/8 lock (8)
+These items are common to Kit Nos. 042 886
and 043 055.
Be sure to provide Model when ordering
replacement parts.
5
6
7
Shim (8) is installed as a
spacer when cylinder
rack is not used.
When installing Weld Cable
Holder Kit 043 055, use
same holes in welding pow-
er source that are used to in-
stall Three-Phase Running
Gear handle.
1
2
3
4
Remove paint from axle grooves (9)
before installing retaining rings (12).
For more weld cable
wraps around handle,
install handle in this
position.
8
9
10
11
12
13
14
15
16
17
18
10
1
2
4
5
6
7
7
4
When installing running gear and cylinder rack at the
same time, install axle according to Figure 2 or Figure 4.
Figure 1. Installing Three-Phase Running Gear
