Make sure to wear the attached
goggles and glove
when you work.
JFX200-2513 / JFX500-2131
Cleaning procedure of head nozzle
Only when the nozzle drop out doesn’t recover with cleaning, daily care and maintenance, please clean
the head nozzle following the procedure below.
Procedure
1. Remove the left side cover of
the machine.
Remove the screw and remove the
cover.
2. Move the carriage(head) to the maintenance space.
(1) Press the
key in LOCAL.
(2) Press the
key.
(3) Press
to select [HEAD MAINT.].
(4) Press the
key.
• Before performing the maintenance, please make sure to attend the training by our engineers. Maintenance
without training may cause failure of the head.
• During maintenance, never rub the nozzles of the head. If rub the nozzle part, the water-repellent surface is
degraded and the head might need to be replaced.
Supply goods for cleaning
Nozzle swab (100)
Cleaning stick (50)
F200/LF200 Cleaning liquid
for maintenance (100mℓ)
No.SPC-0421
No.SPC-0527
No.SPC-0568
• Make sure to use designated supply goods for nozzle cleaning. Other cleaning goods may cause early
deterioration of the head.
• Head will move for maintenance, please be careful.
[JFX200] Remove the screws
at two positions.
[JFX500] Remove the screws
at four positions.
Cover
Cover
MAINT.
