Instruction Manuals can be downloaded at www.minicam.co.uk/manuals
©2020 Mini-Cam Ltd. All rights reserved. Mini-Cam names and logos are trademarks of Mini-Cam.
Mini-Cam is a Halma Company.
MINI-REEL
CAM030MR
Set-up Guide
Danger!
Risk of deadly injuries from electrical
current
• Take precautions to ensure that
fluids cannot enter electrical
enclosures.
• Ensure that the electrical connection
cables are intact and that they
cannot be bent or crushed. If you
find cable damage, immediately
disconnect the power supply and
inform the appropriately trained staff
or Mini-Cam Service Centre.
•
Maintenance and repair work
Shall only be carried out by trained
specialist staff at an approved Mini-Cam
Service Centre.
Caution!
Risk of injury
Lift and carry the frame and basket
correctly to avoid physical damage! When
preparing the system for operation pay
attention to the frame position, that it is
on a flat, level surface.
Caution!
Never alternate the use of the inspection
system between fresh water and
wastewater system inspections. Bacteria
can lead to contamination. All individuals
employed for the inspection work must
be advised of the hazards and must
be instructed in the required safety
measures.
SAFETY INFORMATION
Read all instructions before first use
D
ES
IG
N
1
22
0
Maintenance
To ensure the maximum service life of the
Mini-Reel inspection system,
the individual modules and accessories
belonging to the system have to be
independently maintained and kept clean.
Moving parts, in particular, can have
improved operational life by frequent
professional cleaning after inspections.
Also, the risk to the operator of infection
can be significantly reduced by using a
cleaned system.
Take notice of the following comments
on general maintenance:
• Keep the entire system clean and clean
the system directly after each inspection.
• Thoroughly wash down the parts of the
system that have come into contact with
moisture and then dry them with a clean
and dry cloth, or dry airflow.
• Keep all electrical connections and
contacts free of dirt, grease and
moisture at all times.
• Cleaning agents or solvents must not
be used. These can damage the
seals and other materials on the system.
• Clean the rod with a cloth when retracting.
• Check O-rings for damage and replace if
necessary, and grease regularly with
O-ring lubricant.
• Only clean the camera and light lenses
with a specific lens cleaning cloth
to prevent scratches.
• Immediately fit the protective caps after
removing electrical connections.
