background image

Thank you for choosing this product.

WARNING - AVOID SERIOUS INJURY 

FROM FALLING OR SLIDING OUT. 

ALWAYS USE COMPLETE 5 POINT 

SAFETY HARNESS
lMPORTANT!

KEEP FOR FUTURE REFERENCE

Phillips screwdriver required

Rayne Highchair

1

mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558

Assembly Instructions

•  Read these instructions carefully. Failure to 

follow them may put the child’s safety at risk.

•  The product must be assembled and 

adjusted by an adult. Do not use the product 

if it is not properly assembled, if it is broken 

or if pieces are missing.

•  Prevent the child from falling or slipping; 

always use the 

 ve-point safety harness. Use 

the safety harness both when the seat is 

reclined and when it is in the vertical position.

•  Never leave the child unattended.
•  Stay near and watch child during use.
•  Do not place your 

 ngers in the mechanisms 

and make sure the child’s limbs are safe from 

harm when adjusting the chair.

•  It could be dangerous to use accessories that 

are not approved by the manufacturer.

•  Assembly, preparation, cleaning and 

maintenance of the product must only be 

carried out by adults.

•  Do not leave the high chair exposed to 

sunlight for long periods of time. Wait until it 

has cooled down before sitting the child in 

the chair.

•  Make sure that any harness is correctly 

 tted.

•  Always use the restraint system.

•  Position the product so that the child is far 

from dangers such as electrical wiring, heat 

sources and 

 ames.

•  Do not use the product near stairs or steps.
•  Be aware of the risk of open 

 re and other 

sources of strong heat,such as electric bar 

 res, gas 

 res etc. in the vicinity of the high 

chair.

•  The child should be secured in the high chair 

at all times by the restraining system. The 

tray is not designed to hold the child in the 

chair. It is recommended that the high chair 

be used only by children capable of sitting 

upright unassisted.

•  Never use this product on an elevated 

surface(e.g. a table).

•  To avoid injury ensure that children are kept 

away when unfolding and folding this product.

•  Do not let children play with this product.
•  This product is designed for indoor use only.
•  Do not move or lift this product with the baby 

inside it.

RECLINER

•  When used as a recliner, this product is 

designed for children from birth up to a 

weight of 9 kg.

Summary of Contents for Rayne










Reviews: