User Instructions
Modulift UK Ltd tel: +44(0)1202 621511 email: sales@modulift.com www.modulift.com
The CMOD Spreader Frame is modular in span and every frame consists of 4 Corner Units,
with intermediate Struts that can be bolted into the assembly to achieve different spans.
●
●
Personnel using this system should be suitably trained, competent and have a clear
understanding of Safe Slinging procedures.
●
●
The use of Modulift equipment must be in accordance with the procedures laid down in
‘Lifting Operations and Lifting Equipment Regulations 1998’ (LOLER).
●
●
Never exceed stated WLL
– Adhere to WLL in Table 2 for particular sling angle used.
●
●
The top sling length is critical to the safe use of the spreader
– Ensure you refer to the correct table.
WARNING!
β = Sling to vertical angle (STV)
CMOD 110 Spreader Frame
CMOD 110 has an assembled span ranging from 2m by 2m to 16m by 16m and all spans inbetween.
CMOD 110 Frame Specification
●
●
Rated at a maximum of 140 tonnes WLL.
Please see Table 2 for WLL at specific spans.
●
●
‘Sling to Vertical’ angle, β, 45 degrees or less.
●
●
Corner Units are rated at 35 tonnes each
(140 tonnes combined capacity).
●
●
Bolt tightening torque: 150Nm. Spanner size required: 30mm.
●
●
Recommended additional equipment: Torque Wrench, Podger Spanner and Ring Spanner.
P7
P2–P5
Span
β
P6
P1
P8
Table 1 – Component List
Part Ref. Description
Weight/item
P1
Corner Unit
(
length 1m each)
495kg
P2
4.0m Strut
367kg
P3
2.0m Strut
212kg
P4
1.0m Strut
134kg
P5
0.5m Strut
96kg
P6
85t Shackle
62kg
P7
55t Shackle
40kg
P8
M20 x 65, Grade 8.8, HT Bolts, Nuts & Washers
Strut
Corner Unit
Assembled
Frame
Fig. 1 – Typical CMOD Spreader Frame Assembly
