background image

INSTALLATION AND OPERATION INSTRUCTIONS

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT TO INSTALL OR OPERATE.

INTRODUCTION

The transmitter operates on a 12V (A23) battery that is included. Install the 12V battery sup-

plied with the unit into the battery compartment. It is recommended that ALKALINE batteries 

always be used for this product. 

Be sure the batteries are installed with the (+) and (-) 

ends facing the correct direction.

The LED signal light should illuminate when either the on or off button is pressed.  If the sig -

nal light does not illuminate, check the position of the transmitter’s battery, and if the battery is 

fully charged.

TRANSMITTER

This remote control system can be used for the Montigo R-Series fireplaces. 

The system can be operated manually from the receiver using the slider switch. 

ON

OF F

FRON T

BAC K

SIGNAL

LIGH T

ON/OFF

BUTTONS

BATTERY

COMPARTMENT

 MODEL: RXM1410A

When plugged into a standard 110-120 VAC receptacle, the remote receiver operates on 

commands from the transmitter or from the slide switch on the face of the receiver  

ON

• 

: will manually turn on the fireplace.

REMOTE

• 

: will allow use of handheld transmitter. If the system does not respond to the 

transmitter on initial use, check the battery positions in the remote. If that does not work, 

see the SECURITY CODE section. 

OFF

• 

: will disable the remote receiver.

It is suggested that the slide switch be placed in the OFF position if you will be 

• 

away from your home for an extended period of time. 

Slide

Switch

OFF

REMOTE

ON

LEARN

VALVE

ANTENNA

REMOTE RECEIVER

Connection to 

Terminal 4 + 5

To 110VAC

input

RECEIVER

Before installation, make sure you turn the slide switch to 

• 

OFF

. After installation, make sure you turn the slide switch to 

REMOTE

.

The remote receiver can be placed close to the electrical control box. 

 

 

 

   

 

 

 

 

 

 

 

 

• 

INSTALLATION

Protection from extreme heat is very important. The remote receiver should be kept away from temperatures exceeding 130ºF. Extreme 

heat can cause damage, which is not covered under warranty.

Page 1

ON/OFF Remote with 110V receiver and battery for R-Series Fireplaces 

XG0678 - 112113.1

Reviews: