Requirements
▪
A 12-70V DC power supply.
▪
A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7/8/10/11.
▪
ST Configurator™
software (available at www.applied-motion.com/products/software).
▪
A 3004-277-5M power cable, 3004-290-5M I/O cable, or a 3004-280-5M Ethernet cable, as needed.
▪
NOTE: Cables are NOT included and must be purchased separately.
▪
For more detailed information, please download and read the
SWM24 Hardware Manual
, available at www.applied-
motion.com/support/manuals.
To begin, make sure you have the following equipment:
Step 2
DO NOT
apply power until all connections to the drive have been made.
a)
Download and install the
ST Configurator™
software.
b)
If you intend to connect the drive directly to your PC, configure your computer to use IP address 10.10.10.11. (For
instructions on connecting your STM drive to a local area network (LAN), please consult the
STM23 Hardware
Manual)
c)
Do not connect the Ethernet cable to the SWM24 before applying power. This will cause the drive to use its
recovery address, thus assigning itself IP address 10.10.10.10. (See the
SWM24 Hardware Manual
for further
details on selecting IP addresses for the drive and PC)
d)
Launch the software by clicking: Start / All Programs / Applied Motion Products / ST Configurator
Step 1
Wire the drive to the DC power source.
(Do not apply power until Step 3)
Note - the SWM24 accepts DC voltages from 12-70V. If using
an external fuse, we recommend a 5 amp fast acting fuse.
(See the SWM24 Hardware Manual for more information about
power supply and fuse selection.)
Connect I/O, if required by your application. A 3004-290-5M
cable will be required.
(See the SWM24 Hardware Manual for more information about
wiring I/O to the SWM24.)
GND
EMI Filter
AC
Power
Input
LINE
LOAD
L
N
N
L
V+
V-
P/N:092.00823.00 (LCR)
4
3
1
2
POWER
DC POWER
SUPPLY
V-
V+
V+
V-
GND
920-0070 Rev C
SWM
SWM24 Ethernet Quick Setup
Guide
PIN
SIGNAL
WIRE COLOR
1
DC +
BRN
2
DC -
WHT
3
DC +
BLU
4
DC -
BLK
METAL HOUSING FRAME GND & SHIELD
SHIELD
CONNECTION CHART