ENOWd – Gateway EnOcean ®
Hardware: V1.31
Firmware: V1.3
1.
GENERAL FEATURES
:
Reading points:
60 wireless input devices and 60 wireless
output devices.
Control:
Via MD BUS e EnOcean®;
Applications:
Interface between wireless devices and
EnOcean® Mordomus;
Installation:
DIN Rail.
2.
GENERAL SPECIFICATIONS
:
Voltage:
12VDC;
Consumption
: 70mA @ 12VDC;
Storage Temperature:
-10ºC to 60ºC;
Operating Temperature:
10ºC to 50ºC;
Maximum Humidity
: 80%, non-condensing;
Physical Specifications:
Dimensions:
105mm X 90mm X 70mm, DIN rail mounting (6
modules); Box Plastic, self-extinguishing UL-94 V0;
Level Protection:
IP20, for indoor use.
3.
COMPATIBILITY
:
PCCWd Compatibility:
Firmware 3.42 or higher.
Mordomus Software Compatibility:
Mordomus Software
v2015.2 or higher;
4.
SECURITY
:
Before making any connections, please read these
instructions carefully.
Never remove the plastic base from DIN rail.
5.
CONNECTIONS
:
Thickness of conductors:
Bus Circuit:
CAT6 Cable F/UTP shielded, twisted;
Power circuit:
Mono-wire or multi-wire at least 0.75 mm²
Table of Connections:
Number
Function
1
GND
2
MD BUS Inputs A
3
MD BUS Inputs B
4
GND
5
MD BUS Outputs A
6
MD BUS Outputs B
14
GND
15
+12VDC
16
GND
17
+12VDC
Connect the 12VDC:
The use of
Mean-Well
,
DR60-12
or
DR30-12
power supplies
is recommended.
Connect the Bus:
To connect the BUS, must be used a pair-Interlace CAT6
cable. For example, Green for
A
and Green/White for
B
,
The shield should be connected to GND.
If the module is the last module at Mordomus Bus, the
jumpers must be placed according to Fig 1 b) to close the
BUS chain. In other situations it should remain as in Fig 1 a).
Manual: ENO-1642-EN
Page
1
/
2
