Fixed Lateral Support Installation Instructions:
MaTRx-PB elite
TRD0193-04
1
1
Pull up the bottom of the cover (release velcro fasteners) to expose the mounting slots/channels in the back pan.
2
2
Determine the desired mounting height/orientation for the lateral pads
(upper or lower mounting slot position).
3
3
If applicable, carefully bend the lateral support(s) to the desired contour
(prior to installation
).
4
4
Loosely install the lateral supports onto the back pan using the hardware provided.
(N
No
otte
e:: hardware is installed from
the outside of the back pan and threaded through the lateral support brackets into the backing plates (x4) -see
images below).
5
5
Adjust laterals to the desired position via the mounting slots on the backpan
and
via the slots in the lateral support
bracket. Secure each lateral support into place.
6
6
Re-attach the back cover via the velcro fasteners.
Instructions for Installing Fixed Lateral Supports (
Standard
Standard and
Offset
Offset):
Lower
Mounting
Slots
1
Upper
Mounting
Slots
horizontal adjustment
1
Note:
lower mounting slots not available on 12” (31
cm
) high MaTRx-PB elite backs
3
3”” ((7
76
6
m
mm
m
))
REAR VIEW
FRONT VIEW
Standard
Lateral
(large)
Standard
Lateral
(small)
Offset
Lateral*
*note:
offset laterals may be mounted to the back pan in
either orientation (as shown) to provide extended support
FRONT VIEW
Lateral Support
Bracket
3
3”” ((7
76
6
m
mm
m
))
vertical
adjustment
y