background image

866.527.7637 

411@motoalliance.com

 

 

 

23001 Industrial Blvd, Rogers, MN  55374 / 1-866-527-7637 

www.motoalliance.com 

 

Denali PLOW MOUNT 

MA11737 

Teryx 4 ‘12+ 
Teryx 2 ‘14+ 

 

Thank you for purchasing our Denali plow mount(s). You now own a premium, 
custom plow mount to allow you to use your plow with your SxS. Please note the 
following instructions and heed all warnings.  

 

Your UTV/SxS and/or plow system can cause death or injury, please use 
caution and common sense when operating your unit. 

 

Read your Plow Operator’s Manual, your Winch Operator’s Manual, and all 
warning labels before operating your UTV/SxS. 

 

Operate your SxS at a walking speed with the blade installed. Do not 
exceed 5 mph (8 km/h) even with the blade up. 

 

Do not operate the UTV/SxS on slopes greater than 10 degrees with the 
plow installed. 

 

Always lower the plow to the down position before leaving your UTV/SxS 
unattended. 
 

SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.   
 
 
 

Summary of Contents for Denali MA11737

Page 1: ...TV SxS and or plow system can cause death or injury please use caution and common sense when operating your unit Read your Plow Operator s Manual your Winch Operator s Manual and all warning labels before operating your UTV SxS Operate your SxS at a walking speed with the blade installed Do not exceed 5 mph 8 km h even with the blade up Do not operate the UTV SxS on slopes greater than 10 degrees ...

Page 2: ...e verify that all hardware and parts are included in your package Kit Content Please refer to Figure 1 Item Qty Description 1 1 MA11737 Plow Mount 2 1 Winch Spacer 3 2 3 8 16 x 1 00 HH G5 Bolt 4 2 3 8 Flat Washer 5 2 3 8 16 Nylock Nut G5 6 4 5 16 18 x 3 3 4 HH G5 Bolt 7 4 5 16 Flat Washer 8 2 Hold Down Buckle Figure 1 ...

Page 3: ...metal casing shown in Figure 2 using a M10 wrench and Figure 2 Slide the plow mount over the front end of the Teryx 4 or Teryx 2 and align the two holes with the forward most holes on the front end See Figure the mount using the 3 8 bolts washers and nuts included in your kit do not tighten them at this time as they will be removed later to add the winch mount In this step the bolts will locate th...

Page 4: ... using the four 5 16 bolts and the two buckle pieces included in your kit Figure 4 Included in your plow mount kit is a spacer that is to be used in conjunction with the MotoAlliance winch mount Place the spacer behind the plow mount and on winch mounting area The holes in the spacer will line up with the rear holes of the Teryx 4 winch mount location Remove the 3 8 bolts from Step 2 align the win...

Reviews: